Fine paints of Europe are considered as one of the best member of the U.S. Green Building Council. These paints are eco-friendly and the primers meet all requirements for compliance with low emitting materials. These types of paints are a bit expensive since they are produced to be the best way they possibly can be. They contain no inexpensive fillers or extenders, and they are mainly composed of only the finest pigments, oils, and resins. The pigments, oils, and resins are conditioned and combined to yield the most interesting and extremely durable finish.
Fine paints of Europe are often applied on doors. For the doors, people usually apply two coats of satin paint to achieve a very good finish. Mentioned below are the most important things to consider when painting doors with Fine Paints of Europe.
Choose the Best Primer:
When it comes to paint the door, you need to choose the best primer. You can use FPE oil primer or ECO primer for wooden doors. However, use AC Primer for metal doors and Key primer for fiberglass doors. It is important to properly sand the wooden and steel doors with medium grit sandpaper. You can wrap the sandpaper around a household sponge or a rubber sanding block. You should never stand without a backing. For fiberglass doors, use fine sandpaper to sand the surface lightly.
Doors should be primed in a perfect manner. It is recommended that the upper and lower section of your door be primed as well in order to prevent moisture. This will extend the life of your finish as well. If you are using Key Primer, use an inexpensive foam throwaway brush to apply the primer. Remember, Key Primer should only be thinned with water. Once the priming is done, allow the door to dry overnight and wipe the surface with a cotton rag containing a splash of spirit.
Applying Paint on Doors:
Once priming is done, apply the first coat of paint in a thin, even fashion and allow the paint to dry overnight. It is also important to sand the surface of the door again in order to remove all imperfections. This will also provide the surface with a brilliant tooth for the final coat. Once again, wipe the door with a clean cotton cloth to remove dust from the surface.
Apply the final coat very promptly and do not move back on your work or try to eliminate brush strokes. All strokes are going to normally level out within 15 minutes of application.